Status Monitoring - 3Com SuperStack II Switch 3000 10/100 User Manual

Status Monitoring

The status screen provides read-only information
about the Switch. This information may be useful
for your technical support representative if you
have a problem.
To access the screen, from the Main Menu, select
the STATUS option. The Status screen is displayed
as shown in Figure
The Status screen shows the following:
System Up Time The time the unit has been run-
ning since the last reset or power-off/on cycle.
Number Of Resets The total number of system
resets since the Switch was first installed or initial-
ized; either power-on, manual reset or a watchdog
expiry.
Last Reset Type Other / Command / Watchdog /
Power-reset / System-error This field indicates the
cause of the last reset. It may be due to manage-
ment command, watchdog timeout expiry, power
interruption, a manual reset or a system error.
Hardware Version The hardware version number
of the Switch.
Upgradable Software Version The version
number of the agent software image stored in
Flash EPROM. This version number is automatically
updated when you download new software.
6-5.
Figure 6-5 Status screen
Boot Software Version This is the version number
of the Boot software stored on the Switch.
FAULT LOG Select this button to display the Fault
Log, described in the next section.
Status Monitoring 6-9