Correct Use; Safety Parameters; Reasonably Foreseeable Misuse; Residual Risks - WAGNER GM 1-350 Operating Manual

VERSION 02/2015
OPERATING MANUAL
2

CORRECT USE

2.1

SAFETY PARAMETERS

WAGNER accepts no liability for any damage arising from incorrect use.
Use the device only to work with the products recommended by WAGNER.
Only operate the device as a whole.
Do not deactivate safety fi xtures.
Use only WAGNER original spare parts and accessories.
The device may only be operated under the following conditions:
The operating staff must be trained on the basis of this operating manual.
The safety regulations listed in this operating manual must be observed.
The operating, maintenance and repair information in this operating manual must be observed.
The statutory requirements and accident prevention regulation standards in the country of use must be
observed.
2.2

REASONABLY FORESEEABLE MISUSE

The forms of misuse listed below may result in physical injury or property damage:
coating work pieces which are not grounded;
unauthorized conversions or modifi cations to the system;
processing dry or similar coating products, e.g., powder;
using defective components, spare parts or accessories other than those described in
the "Accessories" chapter of this operating manual;
continuing work with a defective or kinked product hose;
working with incorrectly set values;
processing food.
2.3

RESIDUAL RISKS

Residual risks are risks which cannot be ruled out even in the event of correct use.
If necessary, warning and prohibition signs at the relevant points of risk indicate residual risks.
Residual risk Source
Skin contact with Handling of
lacquers and lacquers and
cleaning agents cleaning agents
Lacquer in air Lacquering outside
outside the defi ned the defi ned
working area working area
ORDER NUMBER DOC2349369
Consequences
Skin irritations,
allergies
Inhalation of
substances
hazardous to health
GM 1-350/530
Specifi c measures
Wear protective
clothing,
observe safety data
sheets
Observe work
and operation
instructions
Lifecycle phase
operation,
maintenance,
disassembly
operation,
maintenance
5