WAGNER GM 1-350 Operating Manual page 21

VERSION 02/2015
OPERATING MANUAL
8.1.3
FLUSHING AND CLEANING THE SPRAY GUN
Product
Observe safety instructions in Chapter 4.
The spray gun and the device must be cleaned and fl ushed daily. The cleaning/fl ushing
agents used for cleaning or fl ushing must correspond with the working material.
Note:
Methylene chloride is not recommended as an agent for fl ushing or cleaning the spray
gun or other system components.
1. Relieve the pressure on the spray gun and product pressure generator in
accordance with Chapter 7.3.2.
2. Secure the spray gun with the locking device.
3. Connect the solvent supply.
4. Disassemble the Airless nozzle and clean it separately (see Chapter 7.3.3 and 7.3.4).
5. Raise the pressure of the rinsing agent supply to a maximum of 4 MPa; 40 bar;
580 psi, unlock the spray gun and thoroughly rinse it.
6. Relieve the pressure on the spray gun and product pressure generator.
7. Secure the spray gun with the locking device.
8. Clean the spray gun body with a cleaning agent recommended by the lacquer
manufacturer and dry with a cloth or blow gun.
ORDER NUMBER DOC2349369
B_5045
GM 1-350/530
Locking device in secured
position
21