WAGNER GM 1-350 Operating Manual page 10

VERSION 02/2015
OPERATING MANUAL
Only electrically conductive tanks may be used for cleaning and fl ushing agents.
The containers must be grounded.
An explosive gas/air mixture forms in closed containers.
Never spray into a closed tank when using solvents for fl ushing.
External cleaning
When cleaning the exterior of the device or its parts, also observe the following:
Disconnect the pneumatic supply line.
Use only moistened cloths and brushes. Never use abrasive agents or hard objects, and
never spray cleaning agents with a spray gun. Cleaning the device must not damage it
in any way.
Ensure that no electrical component is cleaned with nor even immersed into solvent.
4.2.5
HANDLING HAZARDOUS LIQUIDS, VARNISHES AND PAINTS
When preparing or working with lacquer and when cleaning the device, follow the
working instructions of the manufacturer of the lacquers, solvents and cleaning agents
being used.
Take the specifi ed protective measures, in particular wear safety goggles, protective
clothing and gloves, as well as skin protection cream if necessary.
Use a mask or breathing apparatus if necessary.
For suffi cient health and environmental safety: Operate the device in a spray booth or
on a spraying wall with the ventilation (extraction) switched on.
Wear suitable protective clothing when working with hot products.
4.2.6
TOUCHING HOT SURFACES
Hot coating products!
Burns
Only touch hot surfaces (temperature > 43 °C; 109 °F) if you are wearing protective
gloves.
When operating the device with a coating product with a temperature of > 43 °C;
109.4 °F:
- Identify the device with a warning label, "Warning – Hot surface".
Order No.
9998910 Instruction label
9998911 Protection label
Note: Order the two stickers together.
ORDER NUMBER DOC2349369
WARNING
Wear antistatic protective gloves.
When operating the device with a coating product with a
temperature of > 43 °C;109.4 °F, identify the device with a
warning label that says "Warning - hot surface".
GM 1-350/530
10