Table of Contents
Advertisement
Chapter 18
18. Power Connector
In some applications, the MOPSlcdLX is intended for use as a stand-alone module without a backplane. You
need to have a power connector available on the board for direct power supply. The MOPSlcdLX is a +5V only
board. Peripherals can obtain additional voltage from the power connector next to the PC/104 bus. The
additional voltages (+12V, -5V and -12V) are not generated onboard the MOPSlcdLX.
18.1 Connector
The power connector is available as X10000C (8 pins).
The following table shows the pinout.
1
To find the location of the power connector on the MOPSlcdLX board, please see the Appendix "Connector
Layout".
18.2 Power Pins
Every power pin on the power connector as well as on the PC/104 bus connector is limited to a maximum
current of 1A per pin.
If a system using a MOPSlcdLX is only supplied from the power connector, the following limitations apply:
Kontron User's Guide MOPSlcdLX
Header
Pin
Signal Name
1
2
2
3
4
8
5
6
7
8
Power
Number of Pins
VCC (+5V)
+12V
-12V
-5V
GND
31
Function
GND
Ground
VCC
+5V
BATT
Battery
+12V
+12V
-5V
-5V
-12V
-12V
GND
Ground
VCC
+5V
Max. Current
2
2A
1
1A
1
1A
1
1A
2
2A
Power Connector
Advertisement
Table of Contents
