Table of Contents
Advertisement
11
Optional features
The b-plus ePDAnano baseboard was designed for the first available Kontron nanoETXexpress module
nanoETXexpress-SP. So the following features on the baseboard can be adjusted for making the whole
platform better suitable for an industrial application. Please contact the support if you require one of
these options in a series application with ePDAnano.
11.1
ATX mode / AT mode
It is not possible to configure a "Last Power State" or "Always On" in the BIOS because the
nanoETXexpress-SP module makes an automatic detection of ATX or AT mode. The ePDAnano is
configured for ATX mode by default. This means that the power button must be pushed to boot the
module.
To manually configure the AT mode a small hardware change is necessary.
remove R48 -> to cut off the standby voltage to the module
®
remove R98 and solder it on position R140 -> all peripheral systems are permanently
®
enabled
Optional Power Connector
11.2
The alternative power connector has greater pull out forces and is recommended for industrial
environments.
The DC10A power connector X6 can be replaced by these positions:
X11
CON-PHOENIX-MC1.5/2-G-3.5
X17
CON-PHOENIX-MC1.5/2-ST-3.5
11.3
Disclaimer for customer modifications
All modifications described in chapter 10 are done by the customers at own risk. Kontron or b-plus does
not guarantee for correct function.
Kontron User's Guide nanoETXexpress-HMI
Baseboard (ePDAnano)
MC 1,5/ 2-G-3,5
1844210
MC 1,5/ 2-ST-3,5
1840366
34
11 Optional features
Phoenix Contact
RM 3,5 mm
Phoenix Contact
RM 3,5 mm
Advertisement
Table of Contents
