Replacing The Power Supply; Removing The Power Supply - Promise Technology SmartStor DS4600 Product Manual

SmartStor DS4600 Product Manual

Replacing the Power Supply

The SmartStor DS4600 uses the following power supply:
• Make and model: Edac EA11003E
• Input: 100 to 240 V, 2.5 A, 50-60 Hz
• Output: 12V, 8.33A max. through a DIN 22, 4-pin connector

Removing the Power Supply

To remove the old power supply:
1. Shut down the SmartStor.
See "Shutting Down the SmartStor" on page 28.
2. Unplug the power cord.
3. Turn the SmartStor enclosure upside down.
4. Press the two latches on the underside of the enclosure, release and remove
the cover.
5.
Bottom of
enclosure
6. Press the power supply retainer back, slide the power supply forward and lift
the power supply out of its cradle.
7. Unplug the motherboard power connector.
If your SmartStor is still under warranty, contact Technical Support
for repair under RMA. See page 82.
Important
Latches
98
Feet (4)