Conversion From Ng To Lpg - HAMPTON BAY HG35-NG1 Owners & Installation

CONVERSION FROM NG TO LPG KIT #486-968
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Conversion Kit contains:
Qty. Part # Description
1 904-529 Allen Key 5/32 Long
1 904-645 Burner Orifi ce #51
1 918-590 Label "Converted to LP"
1 908-528 Red "LPG" label
1 910-037 #30 ULPG Pilot Orifi ce
1 918-579 Instruction Sheet
1) Shut off the gas supply and unplug the
power cord.
2) Remove the Cast Top, Glass Front, Logs
and Lava Rock.
3) Remove burner.
4) Remove burner orifi ce with a 1/2"
wrench and discard. Use a wrench to
hold on to the elbow behind the orifi ce.
5) Reinstall new burner orifi ce LPG
stamped #51 and tighten.
Pilot Hood Burner Orifi ce
6) Pull out the pilot hood by hand.
Pilot
Hood
Removed
Pilot
Orifi ce
Hampton HG35-1 Direct Vent Freestanding Gas Stove
7) Remove the pilot orifi ce with the allen
key.
8) Put in the new LPG orifi ce with the allen
key, then put back the pilot hood.
9) Adjust the burner areation setting to
8mm and install the burner.
10) Open the bottom door.
11) Carefully pull out the control box.
Note: The control box is held in place by
velcro.
12) Remove the control box cover by
undoing the 3 screws. Maneuver through
antenna.
Antenna
Control Box
Cover
INSTALLATION
13) Remove the jumper using a plier.
Jumper Location
Jumper
14) Stick the conversion label "This unit has
been converted to LPG" over top of the
serial number decal.
15) Replace the yellow "NG" label with the
red "LPG" label.
16) Reverse steps 12 and 11.
21