Table of Contents
Advertisement
INSTALLATION
FLUEING
INTRODUCTION
The Horizontal Termination Kit and the Simpson
Dura-Vent Direct Vent System Model DV-GS
venting systems, in combination with the
Direct Vent Freestanding Gas Stoves, HG35-
NG, HG35-LPG, and HG35-ULPG have been
tested and listed as direct fl ue heater systems
by AGA.
These units use the "balanced fl ue" technology
Co-Axial system. The inner liner fl ues products
of combustion to the outside while the outer pipe
draws outside combustion air into the combus-
tion chamber thereby eliminating the need to
use heated room air for combustion and losing
warm room air up the chimney.
Note: These fl ue pipes must not be
connected to any other appliance.
The gas appliance and fl ue system must be fl ued
directly to the outside of the building, and never
be attached to a chimney serving a separate solid
fuel or gas burning appliance. Each direct vent
gas appliance must use it's own separate fl ue
system. Common fl ue systems are prohibited.
IMPORTANT
Read all instructions carefully before starting the
installation. Failure to follow these instructions
may create a fi re or other safety hazard, and will
void the warranty. Be sure to check the fl ueing
and clearance to combustible requirements.
Consult your local building codes before begin-
ning installation.
The location of the termination cap must conform
to the requirements in the Exterior Flue Terminal
Locations diagram.
8
INSTALLATION
PRECAUTIONS
These fl ueing systems are engineered products
that have been designed and tested for use with
the HG35-NG, HG35-LPG, and HG35-ULPG.
The warranty will be voided and serious fi re,
health or other safety hazards may result from
any of the following actions:
1) Installation of any damaged Direct Vent
component
2) Unauthorized modifi cation of the Direct Vent
System
3) Installation of any component part not manu-
factured or approved by Simpson Dura-Vent
or FPI Fireplace Products International
Ltd.
4) Installation other than as instructed by Simp-
son Dura-Vent and FPI Fireplace Products
International Ltd.
WARNING: Always maintain re-
quired clearances (air spaces) to
nearby combustibles to prevent a
fi re hazard. Do not fi ll air spaces
with insulation.
Be sure to check the fl ue termination clearance
requirements from decks, windows, soffi ts, gas
regulators, air supply inlets and public walkways
as specifi ed in the Exterior Flue Terminal Loca-
tions section and in your local building codes.
The gas appliance and fl ue system must be
fl ued directly to the outside of the building,
and never be attached to a chimney serving
a separate solid fuel or gas-burning appli-
ance. Each direct vent gas appliance must use
it's own separate fl ue system. Common fl ue
systems are prohibited.
SAFETY
PRECAUTIONS FOR
THE INSTALLER
1) Wear gloves and safety glasses for protec-
tion.
2) Exercise extreme caution when using lad-
ders or on roof tops.
3) Be aware of electrical wiring locations in
walls and ceilings.
FLUE RESTRICTOR
POSITION
To set the Flue restriction as indicated in the
Flueing Arrangement diagrams on page 10,
simply loosen the screws and push the fl ue
restrictor plate to the correct position. Tighten
the screws.
Horizontal Termination:
Flue Restrictor setting at 36,000 Btu/h
Vertical Termination:
Flue Restrictor setting at 36,000 Btu/h
Hampton HG35-1 Direct Vent Freestanding Gas Stove
Advertisement
Table of Contents
