Table of Contents
Advertisement
installation
Conversion Kit #358-969 from NG to LP
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG
Conversion Kit.
LPG Conversion Kit Contains:
Qty. Part #
Description
1
904-163
Burner Orifice #54
1
918-590
Decal "Converted to
LPG"
1
908-528
Red "LPG" label
1
904-529
5/32" Allen Key
1
910-037
LPG Injector
(Pilot Orifice)
1
920-490
Instruction Sheet
Installation of the LPG
Conversion Kit:
1)
Shut off the gas supply.
2)
a) Lift off the Cast Top and Cast Front,
remove the glass front (refer to Glass
Replacement section in the H27 manual)
and carefully remove the logs and lava
rock (refer to Log Installation section in
manual).
b) Remove burner by removing the 2 screws
on each side and then lifting the burner
tray out.
Screws
Note: Use a magnetic type
screwdriver if possible.
920-490
34
Conversion Kit #358-969 from NG to LPG
for H27U using SIT 820 NOVA Gas Valve
IF IN DOUBT DO NOT DO THIS CONVERSION!!
3) Pull off the pilot cap to expose the pilot
orifice.
4)
5)
6)
1
Hampton
®
H27U-NG/H27U-LP Direct Vent Freestanding Gas Stove
H27U-NG/LP
Unscrew the pilot orifice with the Allen key
and replace with the LPG pilot orifice in the
kit and replace pilot cap.
Remove burner orifice with a 1/2"
wrench and discard. Use another
wrench to hold on to the elbow behind
the orifice.
Burner Orifice
Reinstall new burner orifice LPG stamped
#54 and tighten.
02.18.22
Advertisement
Table of Contents
