Conversion Kit #791-969 From Ng To Lp - HAMPTON BAY H35-LP1 Owners & Installation Manual

INSTALLATION

CONVERSION KIT #791-969 FROM NG TO LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part # Description
1 904-529 5/32" Allen Key
1 904-645 Burner Orifi ce #51
1 918-590 Label "Converted to
LPG"
1 908-528 Red "LPG" label
1 910-037 LP Injector (Pilot Orifi ce)
1 918-487 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
1 904-438 Plug Nylon 0.750 Hole,
Black (for H35 only)
1 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator Battery
Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
Installation of LPG
Conversion Kit:
1) Shut off the gas supply.
2) H35-1: Lift off the Cast Top and remove
the glass front. Also, open up the control
panel door.
P90-1: Remove the facade if it is in-
stalled. Remove the glass door (refer to
the glass door section in the manual).
3) Remove the logs, embers, and brick
panels (if used).
28
IF IN DOUBT DO NOT DO THIS CONVERSION !!
4) Remove the 2 screws holding the Burner
Assembly to the fi rebox base. Push the
Burner Assembly to the left and lift out.
Remove the 2 screws, push Burner
Assembly to the left and lift out.
5) Pull off the
pilot cap to
expose the
pilot orifi ce.
6) Unscrew the pilot orifi ce with the allen
key and replace with the LP pilot orifi ce in
the kit and replace pilot cap.
7) Remove burner orifi ce with a 1/2" wrench
and discard. Use another wrench to hold
on to the elbow behind the orifi ce.
8) Reinstall new burner orifi ce LP stamped
#51 and tighten.
9
) Turn control knob to the "OFF"
position.
10
) Remove the black protection cap by
hand from the high-low knob (Fig.1).
11
) Insert a 5/32" or 4mm Allen wrench
into the hexagonal key-way of the
screw (Fig. 2), rotate it counter-
clockwise until it is free and extract it.
12
) Check that the screw is clean and if
necessary remove dirt.
13
) Flip the screw (Fig. 3).
Burner Orifi ce
®
Hampton H35 Direct Vent Freestanding Gas Stove
Fig. 1
Fig.2
Fig.3