HAMPTON BAY HG35-NG1 Owners & Installation page 25

8) Place the Left Top Log D)02-46 on the pin on Log B)02-56 and on
top of the cutout on Log A)02-43.
D)02-46
B)02-56
C)02-44
Pin
9) Place Front Right Log E)02-45 on the two pins as shown.
10) Place the lava rock in the area between the left and right logs, leaving
a space in the middle for log (F) 02-47.
Hampton HG35-1 Direct Vent Freestanding Gas Stove
A)02-43
Cutout
E)02-45
11) Place the notch in Center Log F)02-47 over Log E)02-45 and across
the cutout on Log A)02-43.
Notch
12) Position notch in Front Right Log G)02-48 on Log F)02-47 and push
the bottom right edge against the bracket on the burner tray.
Notch
G)02-48
Side View
The bottom right edge of Log G)02-48 must sit snugly
against the bracket. (Front Log 02-45 has been removed
so that the bracket can be seen.)
13) Test fi re to ensure proper light off (make sure fl ame fl ows smoothly
from one end of burner to the other. If there is any fl ame hesitation,
check that area for any blockage of the burner port.
INSTALLATION
A)02-43
E)02-45
Cutout
A)02-43
E)02-45
Bracket
25