Table of Contents
Advertisement
COPY OF THE LIGHTING PLATE INSTRUCTIONS
AUTOMATIC CONVECTION FAN OPERATION
The fan operates automatically - turn the knob at the top right rear corner to adjust to the desired speed. The fan will turn on as the stove comes up
to operating temperature. After the unit has been turned off and the unit cooled to below a useful heat output range the fan will shut off automatically.
Hampton HG35-1 Direct Vent Freestanding Gas Stove
FOR YOUR SAFETY
READ BEFORE LIGHTING
This appliance must be installed in accordance with
local codes, if any; if not, follow the current
CAN1-B149/ANSI Z 223.1 (Australia: AS5601-2004,
New Zealand: NZS 5261)
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life. Improper
installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Refer to the owner’s information manual provided
with this appliance. For assistance or additional
information consult a qualified installer, service
agency or gas supplier.
A ) BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
- Do not touch any electric switch, do not use any phone
in your building
- Immediately call your gas supplier from a neighbors
phone. Follow the gas supplier’s instructions.
- If you cannot reach your gas supplier, call the fire
department.
B) Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
This appliance needs fresh air for safe operation and
must be installed so there are provisions for adequate
combustion and ventilation air.
CAUTION: Hot while in operation. Do not touch. Severe
Burns may result. Due to high surface temperatures
keep children, clothing and furniture, gasoline and
other liquids having fammable vapors away. Keep
burner and control compartment clean. See installation
and operating instructions accompanying appliance.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
1)
Plug the power cord into a power outlet.
2)
Press and release the ON/OFF button once to start
the unit.
3)
After approximately 3 seconds the spark ignition
system will spark for 25 seconds to light the main
burner.
4)
If the main burner does not light, check the gas
and reset the unit.
TO TURN OFF GAS APPLIANCE
1)
Press the ON/OFF button once.
2)
Turn off all electric power to the unit if service is
to be performed.
DO NOT REMOVE THIS INSTRUCTION PLATE
OPERATING INSTRUCTIONS
918-399a
31
Advertisement
Table of Contents
