Turn Signals System Check; Level Indicators; Lights List - Gilera Runner RSTPurejet Service Manual

Runner RST Purejet

Turn signals system check

The turn indicator circuit is controlled by an inter-
mittent device. If there are any problems with turn
indicator circuit, check:
- 5A fuse indicated in the photo, removing the bat-
tery cover.
- Using a multimeter, check that the BLACK-BLUE
cable to the turn indicator connector has a voltage
of +12V
- To check the efficiency of the lights, apply 12-volt
voltage to the WHITE-BLUE cable of the indicator
switch for the right lights and to the PINK cable for
the left lights.

level indicators

Made up of a fuel level transmitter, digital reading instrument and a fuel reserve light.
If problems occur, check:
- The fuel reserve light
Make sure that the WHITE wire of the instrument unit is under a voltage of +12V with the key switch at
"ON".
Using the multimeter, the ohm values of the fuel level transmitter moving the arm with the floater.
Limit values:
empty tank position = 93 ÷ 103 ohm
½ tank position = 43 ÷ 51 ohm
full tank position = 5 ohm

Lights list

The lighting system turns on when the key is switched to ON.
It is possible to select the high beams using the light switch.
Electrical system
ELE SYS - 13