Runner RST Purejet
Refitting
- On refitting, position the disc correctly, making sure to turn it in the right direction and apply medium
threadblock.
Recommended products
Loctite 242 product description
Apply LOCTITE medium type 242 threadlock
Locking torques (N*m)
Disc tightening screw 6 ÷ 7 N•m
Disc Inspection
-Remove the wheel and check any out of level of
the disc using the specific tool.
-The measurement revealed must be within 0.1
mm. If the measurement, is greater replace the
disc and repeat the test.
- If the problem continues check and if necessary
replace the wheel rim.
Specific tooling
020335Y Magnetic support for dial gauge
Front brake pads
Removal
Proceed as follows:
- Remove the front calliper.
- Loosen the two pins shown in the figure that lock
the two pads.
- Remove the pads, being careful of the pads'
spring clamp.
- Check the thickness of the pads.
Characteristic
Minimum value
1.5 mm
See also
Front brake calliper
Braking system
BRAK SYS - 5