Chassis
Seat
Lift the saddle and remove the screws indicated in
the photograph
Rear handlebar cover
- Remove the front handlebar cover
- Remove the 3 screws indicated in the figure
-After disconnecting the wiring remove the rear
handlebar.
See also
Front handlebar cover
Front handlebar cover
Front handlebar cover
-Remove the rear-view mirrors.
-Remove the two screws shown in the figure, and
at the same time disconnect the fitting in the upper
part of the handlebar cover. Pull the front part up-
wards so as not to damage the fittings made of
plastic.
CHAS - 2
Runner RST Purejet