Removing The Ignition Key-Switch When On *Off*; Front Central Cover; Removing The Ignition Key-Switch When On *Lock* - Gilera Runner RSTPurejet Service Manual

Chassis

Front central cover

Removing the ignition key-switch when on *off*

- Remove the front shield and back shield.
- Insert a small awl in the groove shown in the
photo and pry up until the clamp is removed.
- Remove the lock body.
To fit, repeat the procedure in the reverse direc-
tion.
See also
Legshield
Knee-guard

Removing the ignition key-switch when on *lock*

Remove the shield.
- Remove the switch of the key switch.
- Make a hole on the block using a drill as shown
in the figure.
- Insert the wheel cylinder with the key and with the
anchoring tab facing down halfway on the lock
body taking care that the insertion phase of the key
is oriented matching "ON" (the only position that
enables the cylinder to get into the lock body); now
turn the key leftwards to "OFF" and at the same
time press until the cylinder is completely in.
See also
Legshield
Knee-guard
CHAS - 6
Runner RST Purejet