Runner RST Purejet
Radiator fan
- Set up a receptacle to collect coolant.
- Remove the fuel tank.
- Loosen the clamps and disconnect the 4 lines
from the radiator.
- Remove the radiator by the 4 studs shown in the
figure.
See also
Fuel tank
Frame central cover
Expansion tank
- Remove the front shield.
Remove the screw indicated in the photograph.
- Remove the cap momentarily to disconnect it
from the shield back plate by pulling it downwards.
- Disconnect the expansion tank from the support
anchored to the chassis.
- Prepare a container to collect the coolant.
- Remove the coolant in (top) and return (bottom)
pipes.
Assembly following the procedure in reverse or-
der.
See also
Legshield
Mixture oil tank
- Remove the helmet compartment.
- Disconnect the connector of the oil gauge light and the oil pipe and remove the tank
Chassis
CHAS - 11