Table of Contents
Advertisement
Air conditioning control switch
Released (LED off)
The air conditioner is on.
The air is cooled and/or only
dehumidified according to the
temperature set.
Pressed (LED on)
The air conditioner is off.
However, heating is still enabled
and will activate according to the
temperature set.
Air distribution controls
C
and
They can operate in two modes:
Automatic "AUT"
The air flow distribution is
controlled by the electronic system,
depending on the ambient
conditions and the temperature set.
Manual
This is used to direct the air flow in
the six positions of the respective
areas (driver-passenger).
108
B
Temperature setting controls
They are used to set the desired
temperature in the passenger
compartment.
The "LO" and "HI" (minimum and
maximum) air temperature settings
are activated at the opposite end
positions.
Fan speed control
E
It has three operating modes:
Automatic "AUT"
The air flow is controlled by the
G
electronic system, according to the
selected temperature to be reached
and maintained.
Manual "OFF"
Turn the control to this position to
turn off the air conditioning and to
only allow air inlet from the outside
when the vehicle is moving.
Fan speed
The four setting positions allow the
occupants to select the air flow rate.
A
and
I
Residual heat function
This function allows the user to
maintain the temperature set for the
passenger compartment for a
specific time (15 minutes), even
after the key has been turned to 0.
To activate this function, press the
"REST" before turning the key to 0.
The system will use the hot water
recirculation pump and the first fan
speed to maintain the temperature.
J
Advertisement
Table of Contents
