Table of Contents
Advertisement
If the TYRES screen page is not set as the
main screen, the following screen page
will be displayed.
will be displayed.
The instrument panel calculates the
remaining range and displays the screen
again after 50 Km (31 miles).
When in a "punctured tyre" condition,
screen page
is displayed if the vehicle is
7
driven for more than 100 Km (62 miles)
and screen pages
7
or
8
are displayed
if the vehicle speed exceeds 80 Km/h
(50 mph), as per the display logic applied
for all priority 0 malfunctions.
Following a key-off / key-on cycle, the
on-board panel must display the "System
not calibrated" screen (see page 44). The
TYRES screen page is not accessible by
the driver.
If, during the display cycle of priority level
0 malfunctions (normal tyre puncture),
the driver presses the MODE button, the
Set-up Menu is accessed immediately, as
10
for other priority level 0 malfunctions.
If, during the priority 2 cycle described
above (tyre puncture with Run Flat tyres,
with maximum speed limit not exceeded
and tyres still usable), the driver presses
the MODE button, screen page
played, together with the multi-function
symbol in the warning lights area, as with
all other priority 2 malfunctions, until
the situation is corrected and the system
recalibrated as requested.
The system may not know which wheel is
originating the malfunction and therefore
is not capable of indicating the wheel
involved. If the TYRES screen page is set
as the main page, screen page
displayed.
displayed.
��� ����
��������
If the TYRES screen page is not set as the
main page, when the display cycle has been
completed the symbol will be viewed in the
warning lights area
A
The TYRES screen page showing the pres-
sure of each individual tyre is not accessible
by the driver.
is dis-
9
On vehicles equipped with "Run Flat" tyres,
screen page
is shown instead, alternat-
11
ing with the following screen page
times.
��� ����� �����
11
will be
Subsequently, the symbol is displayed in
the warning lights area
tion has been corrected, as per the display
logic for all priority 2 malfunctions.
If the TYRES screen page is not set as the
main page, when the display cycle has been
completed the symbol will be viewed in the
warning lights area
A
Safety
1
2
(priority level 2).
3
four
12
4
5
6
A
until the situa-
7
8
(priority level 2).
43
Advertisement
Table of Contents
