Failure Signals - Ferrari 599 GTB FIORANO Owner's Manual

Failure signals

The system ECU checks all of the
components every time reverse is
engaged.
A parking sensor system failure will be
signalled on the TFT display.
������� ������
�������
In the event of a failure warning signal,
stop the vehicle and turn the ignition key
to position 0 (Stop). Then try to clean the
sensors or move away from any
ultrasound sources (e.g., pneumatic truck
brakes or pneumatic hammers) and turn
the key back to II. If the situation causing
the malfunction has been corrected, the
system starts working again and the
failure warning buzzer stops.
96
If the failure warning buzzer remains on,
contact the Ferrari Service Network to
have the system checked.
During parking manoeuvres, always
take the greatest care as there may be
obstacles located above or underneath
the sensors.
In certain circumstances, objects
located near the rear of the vehicle are
not detected by the system and
therefore may damage the vehicle or
be damaged themselves.
The signals transmitted by the sensors
can also be altered by damage to the
sensors or by dirt, snow or ice on the
sensors or even by ultrasound systems
(e.g. pneumatic truck brakes or
pneumatic hammers) in the vicinity.
The driver is fully responsible for
parking and other potentially
WARNING WARNING
dangerous manoeuvres. During these
manoeuvres, always make sure there
are no people (especially children)
or animals in the manoeuvring area.
The parking sensors must be
considered an aid for the driver who,
in any case, must never take less care
during potentially dangerous
manoeuvres, even if they are
performed at low speeds.