Table of Contents
Advertisement
In case of malfunctions/events which
need to be displayed through a multi-
function symbol, they will be viewed, at
the end of the display cycle, in one of the
three dedicated sections of area B.
TYRES
In addition to the shared parameters, the
screen page shows:
- the virtual water and oil temperature
gauges (minimised)
- the vehicle symbol with the pressure
and temperature values for each tyre
- the multi-function symbol for
malfunctions (if any).
When the TYRES screen page is displayed
and an event occurs that needs to be
viewed, the display will appear as in the
following example.
��������
������ �� ���
For further information, please see the
"Tyre Pressure and Temperature
Monitoring System" in the "Safety"
section.
About your vehicle
Parameters shared by all
configurations:
�
�
Odometer
The odometer is always viewed on the
TFT display (in area C: by pressing the
ENTER button, the user can select
whether to view the total odometer
one of the two trip odometers 2.
�
2
C
To reset the trip odometers, press and
hold the MODE button. If TRIP B is not
enabled, TRIP A is automatically reset,
whereas if it is enabled, the active
odometer flashes. Use the UP and DOWN
buttons to select the desired TRIP, and
press ENTER to reset the flashing
odometer.
When the odometer is flashing, to return
to the previous screen page press the
MODE button briefly or wait 10 seconds.
1
2
3
1
or
4
5
6
7
8
67
Advertisement
Table of Contents
