Table of Contents
Advertisement
Incorrect fastening of a child re-
straint system increases the risk of
ATTENZIONE
ATTENZIONE
injury to the child in the event of a
collision.
- The seat belts in the vehicle have been
designed and tested to protect persons
weighing at least 36 Kg and taller than
1.50 m.
- To properly protect children outside
these limits, specific restraint systems
with dedicated belts or accessories
capable of adapting the child's position
to the vehicle seat belts must be fitted.
Follow the instructions that the
Manufacturer of the devices is required
to supply when installing and using the
child restraint systems.
On some vehicle models, the passenger-
side seat belt is equipped with a special
retractor, which helps fastening the child
seat properly. To install the child seat,
pull out the seat belt completely. The belt
retractor will only allow the seat belt to
rewind and it will not be possible to pull
it out afterwards. Check that the seat belt
locking system is active by trying to pull
the belt out, without forcing it. If the sys-
tem is active, this will not be possible.
32
To deactivate the system, release the
seat belt in order to allow it to rewind
completely.
The sticker
B
prohibits installing a child
seat facing rearwards on the front pas-
senger seat.
If you need to carry a child on
the front passenger seat, always
ATTENZIONE
ATTENZIONE
deactivate the passenger-side airbag
using the "passenger airbag deactiva-
tion kit" (optional), on the vehicles
equipped with this device, before
installing the child seat on this seat.
The airbag is deactivated using the switch
C
- which is operated by means of the
specific key - located on the right-hand
side of the dashboard. The switch is ac-
cessible only when the door is open.
The key switch has two positions:
- passenger airbag active: (position ON)
warning light
on the instrument panel
D
off;
- passenger airbag deactivated: (position
OFF) warning light
D
on the instrument
panel on.
�
Advertisement
Table of Contents
