Table of Contents
Advertisement
ECU has completed its diagnostic cycle.
In these conditions, the protection
system has recognised the key code
and deactivated the immobiliser.
�
2) If the CODE warning light
A
remains
on and the EOBD warning light
does not turn off after the ECU has
completed its diagnostic cycle, it
means that the code has not been
recognised. In this case, it is advisable
to turn the key back to position 0 and
then back to II. If the immobiliser
device remains active, try with the
other key provided.
If you are still unable to start the
engine, use the emergency starting
procedure (see page 10) and contact
the Ferrari Service Network.
�
- While driving, with the ignition key in
position II:
B
1) If the CODE warning light
it means that the system is performing
a self-diagnostic cycle. At the first
opportunity, you can stop and test the
system: switch off the engine by
turning the ignition key to position 0,
then turn the key back to position II.
The CODE warning light
on and should go off within one
second. If the warning light stays on,
repeat the procedure described
previously leaving the key at 0 for
more than 30 seconds.
If the problem persists, please contact
the Ferrari Service Network.
2) If the CODE warning light
it means that the vehicle is not
protected by the immobiliser.
ContacttheFerrariServiceNetwork
immediately to have all the keys
WARNING
WARNING
stored in the system memory.
Each key supplied has its own
specific code, which must be stored
WARNING
WARNING
in the memory of the system ECU.
Duplicating the keys
If you request additional keys, provided
that the conditions to satisfy your request
A
turns on,
are met, remember that the codes must be
stored (up to a maximum of 8 keys) on all
the keys.
Contact the Ferrari Service Network
directly and bring the following with you:
A
will turn
General
1
2
3
flashes,
A
4
5
6
7
8
11
Advertisement
Table of Contents
