Connecting Via Bluetooth ® Dongle; Change Interface; Configure Related Settings - Equator S-2 Metapace Hardware Manual

Hide thumbs Also See for S-2 Metapace:
Table of Contents

Advertisement

Metapace S-2 Hardware Manual
3.2 CONNECTING VIA BLUETOOTH

3.2.1 CHANGE INTERFACE

Below is the procedure to configure the scanner before establishing a WPAN connection
via a generic Bluetooth
1) Have the scanner read the "Enter Setup" label to enter the configuration mode.
2) Have the scanner read the desired interface label –
"Activate BT HID & Select Keyboard Type"
"Activate BT SPP"
3) Have the scanner read the labels related to WPAN settings, such as Device Name
Broadcasting, Authentication & PIN Code, etc.
4) Have the scanner read the "Update" label to exit the configuration mode.
5) The scanner will stay active for a specified period of time (2 minutes by default)
waiting for a connection request from the host (SPP) or trying to connect to the host
(HID). Its CPU is running at full speed, and the LED is flashing blue (On/Off ratio 0.5 s:
0.5 s).
Once connected, when getting out of range, the scanner will respond with three short
beeps (tone descending from high to low).

3.2.2 CONFIGURE RELATED SETTINGS

Sniff Mode (Power-saving)
By default, this feature is enabled, meaning the scanner will listen to the wireless network at a
reduced rate.
*Enable
Note: When connecting more than two scanners to a notebook computer or PDA with
®
Bluetooth
setting for a more reliable connection.
88
DONGLE
®
®
dongle.
wireless technology, we suggest that you disable the power-saving
Disable
Enter Setup

Advertisement

Table of Contents
loading

Table of Contents