Selecting Output Interface - Equator S-2 Metapace Hardware Manual

SELECTING OUTPUT INTERFACE

In order to establish a proper connection between your computer and the scanner, we
suggest that you follow these instructions -
1) Install batteries and hold down the trigger for about 2 seconds to turn on the
scanner.
2) Have the scanner read the "Enter Setup" label to enter the configuration mode.
3) Have the scanner read the associated label to activate the desired interface.
See the following sections for output interfaces supported.
4) Have the scanner read the labels for related settings.
5) Have the scanner read the "Update" label to exit the configuration mode.
6) Turn on your computer or laptop and establish a WPAN connection with the scanner.
Refer to Chapter 3 - Setting up a WPAN
Note: By default, the output interface is set to "BT HID".
IN THIS CHAPTER
2.1 BT HID ..................................................................... 45
2.2 BT SPP Slave............................................................. 54
2.3 BT SPP Master ........................................................... 56
2.4 Keyboard Wedge via ................................................. 60
2.5 RS-232 via .............................................................. 68
2.6 USB HID via ............................................................ 73
2.7 USB Virtual COM via ................................................. 82
44
Connection.
Enter Setup
Chapter 2