Quick Start - Equator S-2 Metapace Hardware Manual

QUICK START

The configuration of the scanner can be done by reading the setup labels contained in
this manual or via the software Metapace S-2.exe. This section describes the procedure
of configuring the scanner by reading the setup barcodes and provides some examples
for demonstration.
Configuration Mode
1. Hold down the trigger about 2 seconds to turn on the scanner. It will respond with a long beep
and its LED will come on and off shortly.
2. Have the scanner read the "Enter Setup" label. It will respond with six beeps and its LED
indicator will become flashing red after reading the label.
3. Have the scanner read more setup barcodes... Most of the setup barcodes are normal labels.
The scanner will respond with two beeps (low-high tone). For special labels, it requires reading
more than one setup barcode to complete the setting.
4. Have the scanner read the "Update" or "Abort" label. It will respond with six beeps and its LED
indicator will become flashing red after reading the label.
5. The scanner will restart automatically upon reading the "Update" or "Abort" label. It will
respond with a long beep and its LED will come on and off shortly.
Note: Refer to Appendix I Host Serial Commands
having the scanner read cradle-related setup labels or using serial commands.
8
for how to configure the cradle by
Enter Setup