Bt Hid; Activate Bt Hid & Select Keyboard Type - Equator S-2 Metapace Hardware Manual

2.1 BT HID

For BT HID, refer to
settings. Run any text editor on your computer, and the scanned data will be transmitted
to the computer.
HID Settings
Keyboard Type
Digits Layout
Capital Lock Type
Capital Lock State
Alphabets Transmission
Digits Transmission
Inter-Function Delay
Send "NR" to Host
2.1.1 ACTIVATE BT HID & SELECT KEYBOARD TYPE
When BT HID interface is activated, you will have to select a keyboard type to complete
this setting. By default, BT HID is activated on the scanner, and the keyboard type is set
to PCAT (US).
1) Read the label above to activate BT HID and select a keyboard type.
2) Read the "Decimal
of desired keyboard type.
3) Read the "Validate" label on the same page to complete this setting.
Chapter 3 – Setting up a WPAN Connection
Activate BT HID & Select Keyboard Type ...
Value" label on page 192. Refer to the table below for the number
Chapter 2 Selecting Output Interface
Defaults
PCAT (US)
Normal
Normal
Off
Case-sensitive
Alphanumeric keypad
0 (ms)
Disable
Update
for related connection
45