Character Substitution - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

5.2 CHARACTER SUBSTITUTION

Character substitution is performed on every occurrence of the first character specified. If
only one character is specified, every occurrence of that character in the barcode will be
taken away.
The first character will be replaced by the second character(s).
Up to three sets of character substitution can be configured.
If "BT HID", "USB HID" or "Keyboard Wedge" is configured for interface,
and Key Status
Key Status when "Normal Key" is selected for Key Type. Refer to
Keyboard Wedge
Key Type
Scan Code Only 1 scan code value is allowed.
Refer
Character
Normal Key Up to 3 character strings are allowed.
Note: The character substitution is performed only on the barcode itself and before the
processing of editing formats. It is not applicable to the Prefix/Suffix Code, Code
ID, Length Code, or any Additional Field.
138
will then become applicable. You may decide whether or not to apply
Table.
to 5.2.1 Select a
Substitution.
Key Status
N/A
Set for
Add Shift
Add Left Ctrl
Add Left Alt
Add Right Ctrl
Add Right Alt
Add Break
For example, read labels for [A], [Add
Shift], and [B] to replace the character [A]
with [Shift+B].
Enter Setup
Key Type
Appendix II