Auto-Sense Mode - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

1.11 AUTO-SENSE MODE

When the scanner is seated in the cradle, press the trigger so that it will automatically
enter Auto-Sense mode. In Auto-Sense mode, it will force the scanner to apply Laser
mode as the scan mode. However, it works differently from the original Laser mode. Now
the scanner will be scanning as long as it is seated in the cradle, as shown below.
Whenever a barcode is brought within range, the scanner will be able to decode it.
Note: Remove the scanner from the cradle to exit Auto-Sense mode. It will return to
Laser mode. If Laser mode is not desired, proceed to select a scan mode best suits
your application.
Note: For Auto-Sense mode to work, you must connect both the power supply cord and
the interface cable to the cradle. USB power is insufficient.
When the ambient light is too dim to activate the sensor, you may have the scanner read
the "High Sensitivity" label to improve performance.
High Sensitivity
Note: If the ambient light is under 100 lux, we suggest that you either add lighting or
use Continuous mode instead.
40
*Normal
Enter Setup