Inter-Function Delay - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

2.3.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254,
to match the computer response time of the keyboard interface. Such delay time is
inserted between every function code (0x01 ~ 0x1F) being transmitted. The longer the
delay time is, the slower the transmission speed will be.
Value Delay Time
0 Disable
1 ~ 14 10 millisecond
15 ~ 24 20 millisecond
25 ~ 34 30 millisecond
35 ~ 44 40 millisecond
45 ~ 54 50 millisecond
... ...
1) Read the label above to specify the inter-function delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" label on the same page to complete this setting.
58
Inter-Function Delay ... (*0 ~ 254)
Value" label on page 192 for the desired inter-function delay
Value Delay Time
195 ~ 204 200 millisecond
205 ~ 214 210 millisecond
215 ~ 224 220 millisecond
225 ~ 234 230 millisecond
235 ~ 244 240 millisecond
245 ~ 254 250 millisecond
Enter Setup