Disable Authentication Or Use Random Pin - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

DISABLE AUTHENTICATION OR USE RANDOM PIN

In the configuration mode, read the label below to disable authentication (= No PIN) or
use a random PIN for authentication.
*No PIN or
use random PIN
Note: When using BT HID, some device driver may not support pre-defined PIN code for
authentication. In this case, make sure you have the scanner set to "No PIN or use
random PIN" before pairing. While pairing, the host PIN code will be displayed on
the computer screen.
Use Random PIN
When the target device is set to use a random PIN for authentication, wait until the random PIN is
displayed on the target device while pairing, and then input the matching PIN code on the scanner.
Note: Follow the steps below to enter the matching PIN on the scanner. There is no need
to enter the configuration mode!
1. Read one of the labels to specify the PIN code, in decimal or hexadecimal.
Enter PIN Code
in Hexadecimal ...
2. Read the "Decimal
the desired digits or character string.
Read the "Clear PIN Code" label first if you need to re-input the PIN.
Clear PIN Code
3. Read the "Validate" label to complete this setting.
196
Value" label on page 192 or the
Enter PIN Code
in Decimal ...
"Hexadecimal Value" label on page 193 for
Enter Setup