Inter-Character Delay; Inter-Function Delay - Equator S-2 Metapace Hardware Manual

Enable

2.4.3 INTER-CHARACTER DELAY

By default, the inter-character delay is set to zero. Specify a value, ranging from 0 to
254 in units of millisecond, to match the computer response time of the keyboard
interface. Such delay time is inserted between every character being transmitted. The
longer the delay time is, the slower the transmission speed will be.
1) Read the label above to specify the inter-character delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" label on the same page to complete this setting.

2.4.4 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of millisecond, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the label above to specify the inter-function delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" label on the same page to complete this setting.
Inter-Character Delay ... (*0 ~ 254)
Value" label on page 192 for the desired inter-character delay
Inter-Function Delay ... (*0 ~ 254)
Value" label on page 192 for the desired inter-function delay
Chapter 2 Selecting Output Interface
*Disable
Update
67