Understanding The Barcode Scanner; Battery; How To Operate The Scanner - Equator S-2 Metapace Hardware Manual

UNDERSTANDING THE BARCODE SCANNER

This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Battery..................................................................... 18
1.2 Memory.................................................................... 21
1.3 LED Indicator ............................................................ 24
1.4 Beeper ..................................................................... 26
1.5 Send "NR" to Host ..................................................... 30
1.6 Scan Modes .............................................................. 31
1.7 Scanning Timeout ...................................................... 36
1.8 Delay between Re-read............................................... 37
1.9 Read Redundancy for All Symblogies ............................ 38
1.10 Addon Security for UPC/EAN Barcodes ........................ 39
1.11 Auto-Sense Mode ..................................................... 40
1.12 CCD Sensor Always Active......................................... 41
1.13 Negative Barcodes ................................................... 41
1.14 Effective Decoding Area ............................................ 42

1.1 BATTERY

The scanner is powered by a rechargeable 3.7 V/800 mAh Li-ion battery, and it takes
approximately 5 hours to charge the battery to full (from the power adaptor). However,
the charging time may vary by working condition. For intensive data collection, you may
purchase a spare battery for non-stop operation.
Note: The scanner can be configured to save battery power. Refer to settings of
Power Off &
"Low Battery

1.1.1 HOW TO OPERATE THE SCANNER

Turn on the scanner...
After installing the battery, hold down the trigger for about 2 seconds. The scanner will respond
with a long beep (high tone), and its LED will become solid red and go off quickly.
Turn off the scanner...
Remove the battery directly or let it turn off automatically in specific circumstances.
18
Power-Saving", "CCD Sensor Always
Alarm".
Chapter 1
Active", "Sniff Mode", as well as
Enter Setup
"Auto