Usb Virtual Com Via The Cradle; Activate Usb Virtual Com; Inter-Function Delay; Usb Virtual Com Via - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

2.7 USB VIRTUAL COM VIA THE CRADLE

Use the USB cable to connect the scanner via the cradle to the USB port of PC and
connect the power supply cord if necessary. You may run HyperTerminal.exe on your
computer, and the scanned data will be transmitted to the computer.
Note: If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM. Driver version 5.3 or later is required. Please remove older versions!

2.7.1 ACTIVATE USB VIRTUAL COM

2.7.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254,
to match the computer response time of the keyboard interface. Such delay time is
inserted between every function code (0x01 ~ 0x1F) being transmitted. The longer the
delay time is, the slower the transmission speed will be.
Value Delay Time
0 Disable
1 ~ 14 10 millisecond
15 ~ 24 20 millisecond
25 ~ 34 30 millisecond
35 ~ 44 40 millisecond
45 ~ 54 50 millisecond
... ...
1) Read the label above to specify the inter-function delay.
2) Read the "Decimal
(millisecond).
3) Read the "Validate" label on the same page to complete this setting.
82
Activate USB Virtual COM
Inter-Function Delay ... (*0 ~ 254)
Value" label on page 192 for the desired inter-function delay
Value Delay Time
195 ~ 204 200 millisecond
205 ~ 214 210 millisecond
215 ~ 224 220 millisecond
225 ~ 234 230 millisecond
235 ~ 244 240 millisecond
245 ~ 254 250 millisecond
Enter Setup