Keyboard Wedge Via The Cradle; Activate Keyboard Wedge & Select Keyboard Type; Keyboard Wedge Via - Equator S-2 Metapace Hardware Manual

Hide thumbs Also See for S-2 Metapace:
Table of Contents

Advertisement

Metapace S-2 Hardware Manual

2.4 KEYBOARD WEDGE VIA THE CRADLE

The Y cable allows you to connect the scanner via the cradle to the keyboard input port
of PC and you may join the keyboard as well. The scanned data will be transmitted to the
host keyboard port as if it is manually entered via the keyboard. For example, run a text
editor on your computer to receive the data.
Keyboard Wedge Settings
Keyboard Type
Alphabets Layout
Digits Layout
Capital Lock Type
Capital Lock State
Alphabets Transmission
Digits Transmission
Alternate Composing
Inter-Character Delay
Inter-Function Delay
Send "NR" to Host
Laptop Support
2.4.1 ACTIVATE KEYBOARD WEDGE & SELECT KEYBOARD TYPE
When Keyboard Wedge interface is activated, you will have to select a keyboard type to
complete this setting.
1) Read this label above to activate Keyboard Wedge and select a keyboard type.
2) Read the
"Decimal
of desired keyboard type.
3) Read the "Validate" label on the same page to complete this setting.
60
Activate & Select Keyboard Type ...
Value" label on page 192. Refer to the table below for the number
Defaults
PCAT (US)
Normal
Normal
Normal
Off
Case-sensitive
Alphanumeric keypad
No
0 (ms)
0 (ms)
Disable
Disable
Enter Setup

Advertisement

Table of Contents
loading

Table of Contents