Edit A Concatenation Of Barcodes - Equator S-2 Metapace Hardware Manual

Metapace S-2 Hardware Manual

5.6.1 EDIT A CONCATENATION OF BARCODES

1) Read the label above to start editing a concatenation of barcodes.
2) Code Type setting – read the
the (first) barcode. For example, read "4" and "1" for Code 39.
Code Type Symbology
41 (A) Code 39
42 (B) Italian Pharmacode
43 (C) French Pharmacode
44 (D) Industrial 25
45 (E) Interleaved 25
46 (F) Matrix 25
47 (G) Codabar (NW7)
48 (H) Code 93
49 (I) Code 128
4A (J) UPC-E0 / UPC-E1
4B (K) UPC-E with Addon 2
4C (L) UPC-E with Addon 5
4D (M) EAN-8
4E (N) EAN-8 with Addon 2
3) Barcode Length setting – read the
length of the (first) barcode. For example, read "0065" for barcode length of 65
characters or read "0000" for any length.
Note: If not reading 0000 for any length, the 4-digit length must exclude prefix, suffix
(0x0d by default), length code, etc.
4) Matching Character setting – read the
st
1 character that must be found matching in the (first) barcode. For example, read
"4" and "1" for matching character "A" as the first character in the barcode or read
"00" for any character.
5) Read twice the "F" label on page 193 ("FF") to complete the setting of each barcode.
6) Read the "Validate" label to end the editing of the barcode set.
154
Edit Output Sequence
"Hexadecimal Value" label on page 193 for Code Type of
Code Type
4F (O)
50 (P)
51 (Q)
52 (R)
53 (S)
54 (T)
55 (U)
56 (V)
57 (W)
58 (X)
5A (Z)
5B ( [ )
"Decimal Value" label on page 192 for the 4-digit
"Hexadecimal
Symbology
EAN-8 with Addon 5
EAN-13
EAN-13 with Addon 2
EAN-13 with Addon 5
MSI
Plessey
GS1-128 (EAN-128)
UPC-A
UPC-A with Addon 2
UPC-A with Addon 5
Telepen
GS1 DataBar (RSS)
Value" label on page 193 for the
Enter Setup