Upgrading The Software Locally Using A Computer - Huawei VP9050 User Manual

HUAWEI VP9050 Executive Video Terminal
User Guide
Table 13-2 Methods for upgrading the terminal software
Method
Upgrading the
software locally
Upgrading the
software using the
minimum system
Before the upgrade, note the following:




13.2.2 Upgrading the Software Locally Using a Computer

You can use a computer to upgrade the software of the terminal locally.
Before upgrading, note the following prerequisites:


Upgrading a Single Terminal
You can upgrade a single terminal using the upgrade program installed on the computer.
To upgrade a single terminal, do the following:
Step 1 Power on the computer and the terminal.
Step 2 Extract the compressed file of the upgrade software on the computer.
Step 3 Run UpgradeTool.exe to display the window as shown in Figure 13-1.
Issue 03 (2011-12-10)
Usage
After obtaining the upgrade software, connect a computer to the
terminal directly or over the local area network, and then upgrade
the terminal.
Set the terminal to the upgrade state forcibly. Connect a computer
to the terminal directly or using a switch, turn the switch on the
rear panel of the terminal to Load, and then upgrade the terminal.
NOTE


Read the Release Notes to understand the contents to be upgraded and precautions
required to be taken during the upgrade.
Check whether the current software version is earlier than the target version.
Back up the settings on the terminal, such as the communication settings and the address
book.
A copy of the destination software version is available on the computer.
The computer is connected to the terminal using a straight through network cable,
crossover network cable, or switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
If the hardware of the terminal works properly, the software can always
be upgraded successfully.
If upgrading the software locally fails, you can use this method.
13 Maintenance and Troubleshooting
84