Setting Camera Output Parameters - Huawei VP9050 User Manual

HUAWEI VP9050 Executive Video Terminal
User Guide
Table 4-6 Common settings parameter
Parameter
Remote control
Serial port type
Step 4 Save the settings.
----End

4.2.4 Setting Camera Output Parameters

When cameras of certain models are used along with the terminal, the parameters for these
cameras must be set. For details about how to install and operate a camera, see the documents
provided with the camera.
To set the output parameters of a camera connected to the terminal, do the following:
Step 1 Choose Settings > Video > Video Output.
Step 2 Select DVI/VGA OUT.
Step 3 Set the parameters listed in Table 4-7.
Table 4-7 Camera output parameters
Parameter
Name
Output mode
Video resolution
Refresh rate
Issue 03 (2011-12-10)
Description
This specifies whether a remote site can control the local camera
during a call. By default, Allow is selected.
This specifies the type of the serial port of the camera that is
connected to the terminal. You can select between RS232 and RS422.
The COM serial ports on the rear panel of the terminal are dual-mode
ports that can be used as both RS232 and RS422 interfaces.
Description
This specifies the name of an output interface to simplify identifying
and using the interface during a conference.
This specifies the format of the video received by the display.
VGA: Select this option if connecting the display to a DVI/VGA

OUT interface using a DVI-SXGA conversion cable.
DVI: Select this option if connecting the display to a DVI/VGA

OUT interface using a DVI extension cable.
YPrPb: Select this option if connecting the display to a DVI/VGA

OUT interface using a DVI-YPrPb conversion cable.
For details about how to set the video resolution, see Table 4-10.
For details about how to set the refresh rate, see Table 4-11.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
4 Video Settings
31