Setting H.323 Parameters - Huawei VP9050 User Manual

HUAWEI VP9050 Executive Video Terminal
User Guide
Parameter
Network interface
mode
Step 2 Select Save to save the settings.
----End

3.3.3 Setting H.323 Parameters

The H.323 parameters must be set when the GK is used in the conference system.
To set the terminal's H.323 parameters, do the following:
Step 1 Choose Settings > Network > IP > H.323, and then set the parameters listed in Table 3-4.
Table 3-4 H.323 parameters
Parameter
Enable GK
GK address
Issue 03 (2011-12-10)
Description
This specifies the working mode of both the network interfaces of the
terminal.
Auto detection: When accessing the network, the terminal

automatically communicates with the remote network device to
determine the best network mode.
10 Mbit/s and half duplex: The transmission rate is 10 Mbit/s. Data

cannot be sent and received at the same time.
10 Mbit/s and full duplex: The transmission rate is 10 Mbit/s. Data

can be sent and received at the same time.
100 Mbit/s and half duplex: The transmission rate is 100 Mbit/s.

Data cannot be sent and received at the same time.
100 Mbit/s and full duplex: The transmission rate is 100 Mbit/s.

Data can be sent and received at the same time.
TIP
If the working mode of the network interface of the remote network device is
not known, set this parameter to Auto detection. Otherwise, the terminal may
fail to access the network properly.
The GK is the network isolator of the videoconferencing system and is used to manage the network
bandwidth, terminal authentication, and address translation. It enables calls to be made to fixed site
names and not to variable IP addresses.
Description
This specifies whether the terminal registers with the GK.
If this parameter is enabled, the terminal registers with the GK

after startup. After the terminal registers with the GK
successfully, it can call a remote site using the site number, site
name (defined in the address book), or IP address. For a
conference attended by IP sites, the GK must be used.
If this parameter is disabled, the terminal does not register with

the GK, and it can call a remote site using only the IP address.
This specifies the IP address of the server where the GK is installed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
3 Network Settings
16