Configuring Content Display With People+Content Ip; Using The Polycom Visualboard™ Application - Polycom RealPresence Group 550 Administrator's Manual

Administrator's Guide for the Polycom RealPresence Group Series
You cannot enable or disable H.239 while in a call.
If the audio level of the call using content sharing needs to be adjusted, follow these steps to change the
level:
5 In the web interface, go to Admin Settings > Audio/Video > Audio > Audio Input.
6 Set the Audio Input Level.

Configuring Content Display with People+Content IP

People+Content IP enables a presenter to show content from a computer to other sites in a video
conference using only an IP network connection. The presenter can show PowerPoint
spreadsheets, or any other type of content from a computer. People+Content IP supports any computer
desktop resolution with color set to 16-bit or higher.
Before a presenter can use a computer to show content with People+Content IP, you need to:
● Download the People+Content IP software application from the Polycom web site to the computer or
computers that the presenter will use to show content.
You don't need to change the computer resolutions and you don't need special cables or hardware,
but each computer must meet these requirements:
 Operating System: Windows 7 or 8
 Minimum computer: 500 MHz Pentium® III (or equivalent); 256 MB memory
Recommended computer: 1 GHz Pentium III (or equivalent); 512 MB memory
● Connect the computer or computers to the IP network.
To install People+Content IP on a computer:
1 On a computer, open a web browser and go to the Polycom web site at www.polycom.com/ppcip.
2 Download and install the People+Content IP software.
If the Polycom RealPresence Group system is paired with a Polycom Touch Control,
People+Content IP does not need to be installed. If you connect the PC to the USB connection on the
underside of the Polycom Touch Control, a version of People+Content IP launches automatically.
Using the Polycom VisualBoard™ Application
The Polycom VisualBoard™ application allows you to show and annotate content in real time from Polycom
RealPresence Group systems by using an electronic annotation device such as a touch screen monitor. You
can use the monitor as your only content monitor or you can use it in addition to your current content monitor.
When using a touch screen monitor, you can annotate the content using finger, a stylus, or a mouse. When
using a standard monitor, you can use the UC Board device or a mouse to annotate.
Polycom supports the following touch monitor models.
Polycom, Inc.
Content
®
slides, video clips,
82