Polycom RealPresence Group 550 Administrator's Manual page 60

Administrator's Guide for the Polycom RealPresence Group Series
Settings that don't apply to the selected input are not displayed.
Setting
Enable
Model
Name
Display as
Input format
Optimized for
Tracking Mode
Tracking Speed
Polycom, Inc.
Description
Specifies the input type. You can also choose to Auto select the input type.
For RealPresence Group 300 and RealPresence Group 500 systems, Input 1
is always HDCI, so you will not see an Enable setting here.
For RealPresence Group 550 systems, Input 1 is always HDCI, so you will not
see an Enable setting either.
Note: RealPresence Group 300 systems have only one video input.
RealPresence Group 500 systems have two video inputs, but only HDMI and
VGA are allowed for the second input.
Displays the type of device using the input port.
Displays the default name of the input, but you can enter your own name for
the device.
Specifies whether the input is to be used for People or Content.
The selection you make here determines the available settings for the device
in the embedded interface. For example, a People source has settings for PTZ
and near/far camera control, but a Content source has different settings.
In this release of the RealPresence Group 550 systems, you can only set
Input 1 and Input 2 for People, and Input 3 for Content.
Specifies the source type of the device. This setting is read only unless the
system does not detect the device.
Specifies Motion or Sharpness for the video input.
• Motion — This setting is for showing people or other video with motion.
• Sharpness — The picture will be sharp and clear, but moderate to heavy
motion at low call rates can cause some frames to be dropped. Sharpness
is available in point-to-point H.263 and H.264 calls only. It is required for HD
calls between 512 kbps and 2 Mbps.
Specifies the type of camera tracking:
• Voice — Tracks the speaker. When another speaker starts talking, the view
switches from the first speaker to the room, then to the next speaker.
• Direct Cut — Tracks directly from speaker to speaker if silence intervals are
less than 3 seconds. You must recalibrate the left camera when you select
Direct Cut mode.
If camera tracking has not been calibrated, Tracking Mode is unavailable.
Note: This setting is available only when you have installed an EagleEye
Director.
Determines how quickly the system finds someone new and switches to that
person.
Note: This setting is available only when you have installed an EagleEye
Director.
Monitors and Cameras
60