Setting The Speaker Volume - Polycom RealPresence Group 550 Administrator's Manual

Administrator's Guide for the Polycom RealPresence Group Series
When you set up the system for StereoSurround, the left microphone and speaker should be on the left from
the local room perspective. Place the speaker connected to the audio system's right channel on the right
side of the system, and the other speaker on the left side. The system reverses the left and right channels
for the far site, as shown in the following illustration. This ensures that the sound comes from the appropriate
side of the room.
Figure: StereoSurround Microphone and Speaker Placement
Left
Right
Sending stereo
For best results, place the speakers about 60° apart as seen from the center of the conference table.
Figure: Speaker Placement
Left
speaker
Connect
to left
audio output
(white)
If you use the subwoofer in the Polycom StereoSurround kit, place it beside a wall or in a corner near the
speakers.

Setting the Speaker Volume

To set the volume of an external speaker system:
1 Do one of the following:
Polycom, Inc.
Right
Left
Receiving stereo
output (red)
Microphones and Speakers
Right speaker
Connect to
right audio
73