Polycom RealPresence Group 550 Administrator's Manual page 22

Administrator's Guide for the Polycom RealPresence Group Series
Ref.
Number Description
1 LED indicator light
2 Power sensor
3 Status display area
4 USB 2.0 port
5 Restore button
Use the USB port for any USB 2.0 device.
If your RealPresence Group 700 systems operates with the Maximum Security Profile, the status
display area does not display the software version or IP address.
Brief status and diagnostic messages are displayed in the status display area of the RealPresence
Group 700 system. The LED on the front of all RealPresence Group systems provides the following
information.
Indicator Light
Off
Blinking blue light
Blinking amber light
Blinking red light
Steady blue light
Blinking blue light
Steady amber light
Alternating blue and amber lights
Fast blinking amber light
Steady green light
Polycom, Inc.
System Status
System is powered off.
In a POST sequence, no errors are occurring and tests are successful. The
system continues to blink blue and initializes after the sequence is complete
if no severe errors occur.
In a POST sequence, at least one test has resulted in a warning error. The
system continues to blink amber but initializes after the sequence is
complete if no severe errors occur.
In a POST sequence, at least one test has resulted in a severe error. The
system continues to blink red and will not start up.
System is initializing.
System is awake.
System received an IR (infrared) signal.
System is receiving a call.
System is asleep.
System is in software update mode.
System is in factory restore mode.
System is shutting down.
System is in a call.
Introducing the RealPresence Group Series
22