Smartpairing; Configuring Contact Information - Polycom RealPresence Group 550 Administrator's Manual

Administrator's Guide for the Polycom RealPresence Group Series

SmartPairing

SmartPairing allows you to detect and pair a RealPresence Group system from the RealPresence Mobile
application on an Android or Apple iPad tablet. After you pair the application and the RealPresence Group
system, you can use the RealPresence Mobile application to perform two basic functions:
● Use the application as a remote control for the RealPresence Group system.
● Swipe to transfer a call from the RealPresence Mobile application to the RealPresence Group
system.
Be aware that Telnet must be enabled before you can use SmartPairing. Because Telnet is disabled by
default in all Security Profiles, SmartPairing is also disabled by default.The Telnet enable setting is not
configurable when the Security Profile is set to Maximum or High.
Table: Security Profiles and SmartPairing
Security Profile
Maximum / High
Medium / Low
To configure SmartPairing:
1 In the web interface, go to Admin Settings > General Settings > Pairing > SmartPairing.
2 Configure these settings.
Setting
SmartPairing Mode
Signal Volume
Each paired device is displayed in Diagnostics > System > Sessions.

Configuring Contact Information

You can configure contact information for your Polycom RealPresence Group system so that others know
who to call when they need assistance.
Polycom, Inc.
Telnet Setting Default
Disabled, Not Configurable
Disabled, Configurable
Description
Specifies the method used to pair with the RealPresence Group system, if SmartPairing is
enabled:
• Disabled
• Automatic
• Manual
Specifies the relative signal strength of the ultrasonic signal within the loudspeaker audio
output signal.
SmartPairing Available?
No
Yes. To use SmartPairing, do the following:
1 Enable Telnet.
2 Send API command or use web interface.
Control and Navigation
136