Table of Contents
Advertisement
Silence Suppression:
Enable: Start the voice activity (silence) detection and send SID
when detect silence.
Disable: Send silence packet as normal voice packet (no silence
detection)
RTP Basic Port: The RTP starting port. Each channel will be added
additional 10. For example, the RTP basic port is 16384, thus call 1 will
use 16384 while call 2 will use 16394 etc.
RTP Qos Type: IP QoS tag for RTP stream
> Tone
The setting page is used to setup the tone to be generated or detected. The
detected tone is the Disconnect 1 & 2 (for FXO use) and the others are for
generating (when FXS received the "bye" from IP side or waiting time
out by analog phone which keeps handset pick up, it will send busy
tone to analog phone). The disconnect tone is very important for PSTN
status supervision to release FXO port after call was dropped.
Please use Country Template to select the country profile which will be applied.
Click Use to load those country tone parameters to system and change if
necessary.
For those countries are not showed in the list, please select a
closed country and edit to match your country. You can send an email with the
tone definition to Welltech if you would like to put your country tone into the
list.
DiffServ: The differentiated service QoS tag will be used.
Input DSCP value 0-63 for DSCP.
TOS: Type of Service which include IP precedence value and
TOS.
31
Advertisement
Table of Contents
