Radyne DMD2050 Operation Manual page 192

DMD2050 Universal Satellite Modem
2. :
USER 1 This will allow the operator to change the user name, assign the Access group,
authorized password for "USER 1". Upon entering the following fields will be displayed:
a.
ACCESS GROUP: This will allow the assignment of "No Group", "ADMIN",
"OPER", or GUEST to USER 1.
b. AUTH PASSWORD: This will allow for the entry of the password for USER 1.
c. USER RESET: Using this command will allow the factory defaults (as listed in
the table above) to be restored to USER 1. This can be used in the event that
USER 1 is locked out due to password restriction.
3. USER 2: This has the same menu structure as USER 1.
4. USER 3: This has the same menu structure as USER 1.
Radyne's Web configuration allows for the support of 3 user profiles. These are configured
through the 'PASSWORD/SETUP ACCESS section in the Web Browser.
Change Web User Name
Any of the three available user names can be modified.
1. Go to <USERx> Submenu, press <ENTER> then move the cursor to any position
and press <CLEAR> along with the 'Right Arrow' key to clear all text to the right
of the cursor.
2. Use the arrow keys and the numerical keypad to set the desired user name.
Press <ENTER> to accept the changes.
Change Authentication Password
1. Go to <USERx> Submenu, press 'Down Arrow' to access its corresponding lower
level sub-menus.
2. Go to <AUTH PASSWORD> Submenu, <ENTER> then move the cursor to any
position and press <CLEAR> along with the 'Right Arrow' key to clear all text to
the right of the cursor.
3. Use the arrow keys and the numerical keypad to set the desired password. Press
<ENTER> to accept the changes.
Change Access Rights
1. Go to <USERx> Submenu, press 'Down Arrow' to access its corresponding
lower level sub-menus.
2. Go to <ACCESS GROUP> Submenu, <ENTER> then move the cursor to
any position and press <CLEAR> along with the 'Right Arrow' key to clear all
text to the right of the cursor.
TM110 – Rev. 1.3
Appendix D
D
-3