Radyne DMD2050 Operation Manual page 65

User Interfaces
SAT FRAMING
When SCC Framing is selected above, the following two screens are
SCC CTL RATIO
SCC INBAND RATE
IN-BAND RATE
TERR FRAMING
DATA POLARITY
SYMBOL PAIR
ESC OVERHEAD
AUPC (menu)
AUPC MODE
4-8
{1/15 (IBS), 1/15 (Async), 96 Kbps (IDR), DVB,
EDMAC, EFAUPC, SCC, NONE, EFFICIENT D&I}
Used with IDR, IBS, or Asynchronous Interface Only.
Allows the user to select the framing type.
available.
{1/1, 1/2, 1/3, 1/4, 1/5, 1/6, 1/7}
Allows the user to simulate the framing used by the
Satellite Control Channel Option (Pass Thru Mode only).
The SCC CTL RATIO is the ratio of overhead in-band
data to synchronizing words.
{300 to 200000}
Allows the user to request the rate of in-band data for
the overhead channel.
{150, 300, 600, 1200, 2400, 4800, 9600 19200}
ED&I Only
Available when enhanced async is enabled, this field
allows the operator to set the Earth Station to Earth
station in-band rate. In most cases, this should be set
to the same rate or higher than the ES port baud rate.
When this rate is set lower than the ES port baud
rate, the user must insure that the actual transmission
rate does not exceed the in-band rate, otherwise,
characters will be dropped.`
{NONE, 188, 204} DVB Only
{INV. TERR & BASE, INV. BASEBAND, INV.TERR
DATA, NONE}
Allows the user to invert the Tx Data polarity.
{NONE, SWAPPED}
Allows the user to swap the I & Q Channels.
(BPSK Mode Only)
{VOICE X2, DATA 64KBPS}
IDR ESC Channel used for Voice or 64 K data channel.
Displays when IBS Framing is selected for the Modulator
and Demodulator.
{DISABLED, RADYNE}
DMD2050 Universal Satellite Modem
TM110 - Rev. 1.3