Radyne DMD2050 Operation Manual page 89

Universal satellite modem
Hide thumbs Also See for DMD2050:
Table of Contents

Advertisement

User Interfaces
ROUTER IP ADDR
MODEM EADDR
ETHER RATE
SNMP (menu)
SNMP VERSION
4-32
specified, the address is presumed to be reachable via
the router. Broadcast and loop back addresses will not
be allowed. These are addresses with all subnet bits set
to 0's or 1's.
{XXX.XXX.XXX.XXX}
The IP Address of the Local Network Router. If a router
is present on the local network, this address must be
consistent with the IP Mask and the subnet of the
modem. If no router is present, then the address should
be set to a foreign address. This address is expressed
in hexadecimal format. Broadcast and loop back
addresses will not be allowed. These are addresses
with all subnet bits set to 0's or 1's.
{001065010000}
Displays the Ethernet address of the device. Set at the
factory and is a unique identifier for the Ethernet physical
interface.
{10 MBPS/HD}
The data rate for the local Ethernet Interface.
10 Mbps/HD – for 10 Base-T in either half-duplex or full
duplex.
A description of OID organization is provided in the MIB
portion of this manual (Appendix C).
{V1 & V2, V3}
This selection controls the SNMP Version that will be
used in messaging between the equipment and it's host.
When V1 & V2 is used, RD COMMUNITY and RDWR
COMMUNITY are used to determine the authorization of
an incoming message.
When V3 is used, three contexts are supported: public,
mib2, and dev. Context, Authentication and Privacy are
a portion of each SNMPV3 message.
The public context will only allow the user to see the
sysoid of the unit. This is the most restricted access
possible and only allows the unit to be identified by a
host SNMP Station.
The mib2 context allows a user with appropriate
authentication to access the mib2 OIDs and the SNMP
OIDs. These are of interest primarily to network
operators not controlling the satellite link.
The dev context allows a user with appropriate
authentication to access the device control portion of the
MIB. These OIDs are used to control the devices
satellite link and operation.
DMD2050 Universal Satellite Modem
TM110 - Rev. 1.3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents