Lexmark W840 Finisher Service Manual page 28

4024-XXX
287.05
Paper jam
Check area F
287.06
Paper jam
Check areas G1, G3
287.07
Paper jam
Check area G1
288.00
Paper jam
Check area F
288.01
Paper jam
Check area F
288.02
Paper jam
Check areas G1, G3
288.03
Paper jam
Check area G1
288.04
Paper jam
Check area F
288.05
Paper jam
Check areas G2, G3
2-6
Finisher Service Manual
Sensor (upper media
exit) Static jam A
Sensor (upper media
exit) Static jam B
Sensor (upper media
exit) Static jam C
Sensor (diverter gate)
on jam
Sensor (diverter gate)
Static jam (to top bin) A
Sensor (diverter gate)
Static jam (to top bin) B
Sensor (diverter gate)
Static jam (to top bin) C
Sensor (diverter gate)
Static jam (to stacker
bin) A
Sensor (diverter gate)
Static jam (to stacker
bin) B
Paper remains on the sensor (upper media exit).
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "287.05 Sensor (upper media exit) static jam
A" on page 2-46.
Paper remains on the sensor (upper media exit).
At this time, the sensor (bridge unit media exit) is off
state but the finisher sensor (finisher media entrance)
is turned on.
Go to "287.06 Sensor (upper media exit) static jam
B" on page 2-47.
Paper remains on the sensor (upper media exit).
At this time, both sensor (bridge unit media exit) and
sensor (finisher media entrance) are turned off.
Go to "287.07 Sensor (upper media exit) static jam
C" on page 2-48.
Sensor (diverter gate) is not turned on within the
specified time after the sensor (bridge unit media exit)
is turned on.
Go to "288.00 Sensor (diverter gate) on jam" on
page 2-49.
Paper remains on the sensor (diverter gate) when the
finisher is in the upper bin exit mode.
At this time the sensor (bridge unit media exit) is turned
on.
Go to "288.01 Sensor (diverter gate) static jam (to
top bin) A" on page 2-51.
Paper remains on the sensor (diverter gate) when the
finisher is in the upper bin exit mode.
At this time, the sensor (finisher media entrance) is on
state, but the sensor (bridge unit media exit) is turned
off.
Go to "288.02 Sensor (diverter gate) static jam (to
top bin) B" on page 2-52.
Paper remains on the sensor (diverter gate) when the
finisher is in the upper bin exit mode.
At this time, both sensor (finisher media entrance) and
sensor (bridge unit media exit) are turned off.
Go to "288.03 Sensor (diverter gate) static jam (to
top bin) C" on page 2-53.
Paper remains on the sensor (diverter gate) when the
finisher is in the stacker bin exit mode.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "288.04 Sensor (diverter gate) static jam (to
stacker bin) A" on page 2-54.
Paper remains on the sensor (diverter gate) when the
finisher is in the stacker bin exit mode.
At this time, the sensor (finisher media entrance) is on
state, but the sensor (bridge unit media exit) is turned
off.
Go to "288.05 Sensor (diverter gate) static jam (to
stacker bin) B" on page 2-55.